Reader's Gallery

Shaker blanket Chest

comments (1) January 3rd, 2013 in Reader's Gallery

Chuck_Griffith Charles Griffith, member
thumbs up 11 users recommend

As pieces were added the jig was modified to allow proper angles for clamping.
Compass plane was used to smooth the slight angle at each joint ridge.
 - CLICK TO ENLARGE Photo: Self

Shaker blanket chests usually have a flat top and one or two drawers that pull out from the wide side, so this one is a little different. The arched top was made by coopering slats of cherry whose edges were cut at a 1.25 degree angle. Each slat was glued next to its original neighbor to preserve the grain pattern of the original stock. Glue up was done in a purpose-built jig, then both the outer and inner surfaces were smoothed using an antique compass plane.

Blanket chests are often placed at the foot of a bed where there may not be enough room for pulling out a drawer from the chest's wide side. So instead, this one has a long drawer running all the way through. It can be pulled out from either end.

It's made of solid cherry except for the bottom of the upper chest part. That's made of birch veneer plywood (dyed to match the cherry) to eliminate seasonal wood movement issues.


Design or Plan used: My own design - Charles Griffith
posted in: Reader's Gallery, dovetails, cherry, shaker, chest


Comments (1)

rhlong rhlong writes: Good job Charles. You have made some good improvements to a style that makes it your own. Love the coopered top.
Posted: 9:32 pm on January 6th

You must be logged in to post comments. Log in.

Advertise here for as little as $50. Learn how

Save up to 51% on Fine Woodworking

 

Become a Better Woodworker