How to Apply an Aerosol Finish
Buying and Using Trim Routers
How to Make a Simple Jig for Offset Knife Hinges
How to Cut Sliding Dovetail Joints
Box Making Tips and Tricks
Dedicated Sled Delivers Perfect Finger Joints
Fixing Woodworking Mistakes
Best Tabletop Finish
Five Minute Guide: Glue-Ups
T-Track is a Smart Workbench Accessory
Five Minute Guide: How to Use a Tablesaw
How to Sharpen a Card Scraper
Tablesaw Tapering Jig is Safer and Faster
Router Jig for Perfectly Aligned Dadoes
How to Drill Windsor Chair Mortises
Upgrade Your Jointer with a Segmented Cutterhead
3 Steps to Great Glue-Ups: Sliding Dovetail Joints

Reader's Gallery

Infill plane made from scratch!

comments (2) November 30th, 2012 in Reader's Gallery

jvhovey, member

20 users recommend

Add Comment
Print

To test my skills, I started making infill planes earlier this year. This is my tenth and the one I like the most - also one of only two that didn't end up on my pile marked "This Is How You Don't Do This Stuff, Schmuck."

The infill is spalted pashaco amarillo, or yellow pashaco, which I believe to be a Peruvian jungle wood, now difficult to find in the U.S., and because spalting weakens wood, I cut the tote and bun in half lengthwise and rejoined the two sides again around a sandwich of maple and jatoba, cross-grained.

A furnituremaker friend where I live in Santa Maria, CA, Kevin Manville, liked my early efforts at planemaking, however halting they really were, and gave me a ton of this wood in exchange for a promise to make him a good plane.

The plane in the photo isn't quite good enough for him, so I'm ordering more steel and will get busy on my 11th plane next week. I did everything you see by hand except make the iron and the cap screw - respectively the work of Ron Hock and George Wilson, whose work you may find on Sawmill Creek.

The 3/16-inch sides and 1/4-inch sole are mild steel, held together with double dovetails cut and peened by hand. The iron is bedded at 45 degrees, and the mouth is a mere sliver, so the plane cuts gossamer-like shavings measuring .003-.002 inch.

If anyone's interested, I am scheduled to give a talk and demonstration on planemaking Jan. 3 at a meeting of the San Fernando Valley Woodworkers' Club, in Los Angeles. I expect to do the same in the spring sometime at the Conejo Valley Woodworkers' Club in Thousand Oaks, though this is not yet a date certain.

Design or Plan used: My Own Design - Juan Hovey

posted in: Reader's Gallery, tool, plane, infill, double dovetail

Add Comment Print

some sideboards

Back to List

Maloof Inspired NBA Rocker

Comments (2)

jvhovey writes: RHLong - Actually, I think 45 degrees isn't the best angle. I've just finished another hand plane pitched at 50 degrees (see new posting on Reader's Gallery) and it cuts a fine shaving on tough wood.
Posted: 10:46 am on January 8th

rhlong writes: Good job. I make planes too. Ron Hock makes good plane blades. You inspire me to make an infill. Do you think 45 degrees is the best over all angle?
Posted: 9:56 pm on January 6th

You must be logged in to post comments. Log in.