How to Tame Tricky Glue-Ups
Custom cauls can handle every angle and curve
Synopsis: The key to all glue-ups—especially those on curved parts—is that the clamping pressure must be at an exact right angle to the glueline, and centered on the joint. On angled and curved work, the only reliable way to direct clamping pressure precisely is with specialized cauls. Designing and making these helpers may seem like a hassle at first, but not after you experience the benefits. Here, Michael Fortune explains how to make and use clamped-on cauls for curved work, plus specialized cauls for crown molding, rounded surfaces, and cove molding.
Many woodworkers stop at rectangular work, preferring to stick with flat surfaces and right-angled joints. This is a shame because curves and angles make furniture stand out, and they aren’t as hard as you think. Most importantly, they are fun.
A few factors keep people in the box. Even if they know how to cut smooth curves and precise angles, there still is the problem of gluing and clamping these awkward pieces together. There is a lot of time and material invested at that point, and an open or misaligned joint can be devastating.
This is a follow-up to my two articles on basic glue-ups in FWW #234, which covered 90° joints and basic miters (“Great Glue-Ups Guaranteed,” and Fundamentals: “Gear up for glue-ups”). As I pointed out then, while a dry run is always important for a glue-up, it doesn’t tell the whole story. That is especially the case with curved and angled parts. Once the glue is applied, parts want to slide on the slippery film, freezing in the wrong location a few minutes later when the glue begins to set.
That’s why the key to all glue-ups— especially those on irregular parts—is that the clamping pressure be at an exact right angle to the…